MATERIAL SAFETY DATA SHEET
Product Name: VIP ANTI FRICTION GREASE
Supplier Name and Address:
RIVERS
LUBRICANTS INC.
1335 Riverside Drive
Timmins, Ontario
P4R 1A6
Telephone: 1-800-461-5181
(705) 267-7923
Emergency Tel. # only
(613) 996-6666 (CANUTEC)
WHMIS Classification: Not required by WHMIS
HMIS Classification: HEALTH 1; FLAMMABILITY 1;
REACTIVITY 0
==============================================================================
SECTION II
- INGREDIENTS
==============================================================================
Ingredients ACGIH TLV % (Optional)
Petroleum Oil 5 mg/m 3 70 - 90
EP Agents, Thickeners 10 - 20
==============================================================================
SECTION
III - HEALTH HAZARD INFORMATION
==============================================================================
Inhalation: Not a normal inhalation hazard.
Eye Contact: Causes irritation upon contact
but is not corrosive or damaging to tissue.
Skin Contact: Prolonged or repeated contact
with concentrate may cause skin irritation.
Ingestion: Not normally a form of exposure,
but ingestion will cause irritation and possible indigestion. Low oral
toxicity.
==============================================================================
SECTION IV
- HANDLING PRECAUTIONS
==============================================================================
Wear splash proof safety goggles or a face shield when handling. Avoid
prolonged skin contact by use of oil resistant gloves or clothing as necessary.
==============================================================================
SECTION V
- FIRE AND EXPLOSION DATA
==============================================================================
Boiling Point: N/A
Flash Point: 350^F CAC 177^F CA
Flammable Limits: Not determined
LED/ULL: Not determined
==============================================================================
SECTION VI
- REACTIVITY
==============================================================================
Stability: Stable at normal temperatures and
pressures
Hazardous Decomposition Products: Oxides of
carbon, nitrogen, traces of sulfur
Incompatible Materials: Strong
oxidizing agents
Conditions to avoid: N/A
==============================================================================
SECTION
VII - EMERGENCY AND FIRE FIGHTING PROCEDURE
==============================================================================
Fights as an oil fire.
Respirators are required. Use water fog, dry chemical, foam or carbon dioxide
to extinguish fire.
==============================================================================
SECTION
VIII - SPILLAGE CLEAN-UP AND WASTE DISPOSAL PROCEDURES
==============================================================================
Prevent from entering sewers or watercourses. Pump or
soak up with sand or absorbent. Remove for disposal in an approved landfill
site or incinerate. Consult local laws.
==============================================================================
SECTION IX
- STORAGE INSTRUCTIONS
==============================================================================
Store in a cool dry area. Do not pressurize drum. Do
not cut or weld empty drums. Should product become frozen, warm slowly to room
temperature and mix before using. Keep containers closed.
==============================================================================
SECTION X
- FIRST AID
Inhalation: If worker feels discomfort, remove
to fresh air. Should irritation persist, consult a physician.
Eyes: Flush with water for 15 minutes.
Seek medical attention if irritation persists.
Skin: Wash with mild soap and water.
Remove and launder contaminated clothing before reuse.
Ingestion: Do not induce vomiting as
material may aspirate into the lungs. Seek medical attention and use stomach
lavage if irritation persists.
Prepared by: Rivers Lubricants
Preparation Date: May 8, 2007